QX2500 Glass Washing & Drying Machine
1. Machine feature introduction:
- Main drive is gear drive,inverter speed control and digital
display,Brush roller drive of washing section is drove by upper and
lower motors with separate belts,the rotation frequency conversion
to adjust speed smoothly, longer service life,with independent air
cylinder rise and fall to achieve high requirements of clearing the
special glass.
Ø The machine structure is aluminum alloy assembled structure,never
scrap,permanent service life,energy-efficient ,can save 70% energy.
Ø The sheet metal are sprayed with powder coating or high quality
oil paint.
Ø The rubber roller(Φ75mm) is made of vulcanized rubber fully
coated 304 stainless steel shaft structure (no contact with acidic
liquid).
Ø The whole machine’s bearing seat adopts the new waterproof and
wear-resistant bearing seat developed independently
Ø Cleaning section and water contact parts sheet metal is all 304
stainless steel
Ø The machine has three pairs of brushes (φ160mm), (it can be used
for washing LOW-E glass, ordinary coated glass without scratch the
surface)
Ø Cleaning section,air drying section can lifted 300mm(easy to
cleaning the rubber roller,roller brush,and convininent for machine
maintenance.
Ø The machine has two pairs of air knife which has large wind and
good drying effect. The machine has heating system.
Ø Blower inlet air chamber is equipped with air filter,air knife
section using a variety of muffler measures and exhaust device, to
ensure low noise interference is small;independent frame of
blower,the entire upper blower box installed in the
workshop,convenient to check and clean.
Ø The water tanks can be remove, easy for cleaning, changing water,
checking..etc, it can make washing effect more clean.
Ø Touch screen intelligent display,convenient for staff use, and
simple operation,to use with the glass edging machine is the best
way to reduce labor use.
